17
“For kids who like to move!”
1
1
1
2
3
CONTROL KNOB
Attach Seat Cushion to seat plate:
1. Attach the loop strip on the rear of the seat
cushion to the hook tab on the back and seat
cushion, (fig. 31).
2.
Thread the 1” webbing through the 3-Bar
Slide and leave loose, until proper seat depth
is determined. (fig. 32) Pull tight. (fig 32).
Please see G. for Seat Depth Adjustment.
H
.
RESPOND CX SEAT CUSHION ATTACHMENT
Front
Bottom
Figure 31
Figure 27 B
Figure 32
Figure 28
Figure 29
Back
Underneath Rear
Side
Figure 30
Figure 27 A
Pull To Tighten
Hip Angle Positions
I. HIP ANGLE ADJUSTMENT (RECLINE)
ADJUSTING THE HIP ANGLE (RECLINE)
(equipped with ACTIVATOR™ Dynamic option):
1. Lift kickstand (if equipped) until brakes are fully en-
gaged. If kickstand is not equipped, engage each
brake separately by lifting handle until brake engages.
2. Push down on the control knob with foot until it rests
on the rear axle.
3. While keeping control knob resting on rear axle, grab
handle bar and pull seat back as far as it will go, then
release control knob with foot to lock seat into recline
position.
4. To release from recline and return to upright position,
repeat steps 1 and 2, then push handle bar forward to
upright position.
Figure 33
Figure 34
Figure 35
NOTE:
See next page for instructions on Hip
Angle adjustment for standard chairs (not
equipped with the Dynamic option.
