XM1240S AT Commands Reference Manual
No. XM1240S-A00-106
xmodus swiss GmbH
24 / 46
4.4.5
S7 - Wait Time for Carrier
No function. Only for compatibilty.
4.4.6
S12 - Escape Prompt Delay Time
S12 defines the maximum period, in 20ms units, allowed between receipt of the last
character of the three escape character sequence from the DTE and sending of the OK
result code to the DTE. If any characters are detected during this time, the OK will not be
sent.
Range:
0 – 255
Default: 50
4.4.7
S16 - Last Error Cause
Last occurred ISDN error cause
4.4.8
S30 - Caller Number Verification
S30 controls the Caller Number Verification in Auto-Answer Mode. See also ATMn
Command.
Range:
0,1 (Bit Mapped)
Default: 0
S30=0
Caller Number Verification is disabled (OFF). All calls from remote
modems are allowed and will be accepted.
S30
0
The caller number will be verified at an incoming call. A call is only
accepted, if the caller number is registered in the table of Authorized
Caller Numbers (see ATM command). Otherwise the incoming call is
denied.
4.4.9
S32 - Bit Mapped Options (ATQn Command)
S32 sets the options of ATQn command.
Range:
0,1 (Bit Mapped)
Default: 0
S32=0
Enables result codes to the DTE.
S32
0
Disables result codes to the DTE.
All manuals and user guides at all-guides.com
