XL-SEAT
2002-2008 DODGE RAM 1500 REGULAR CAB PASSENGER
p. 2
PLEASE TAKE NOTE THAT THE PICTURES IN THIS MANUAL WERE TAKEN DURING AN INSTALLATION ON
THE DRIVER SIDE. HOWEVER, THE INSTALLATION PROCEDURE IS THE SAME ON THE PASSENGER SIDE.
1-
Disconnect the battery. Move the seat all the way forward in its tracks. Remove the
storage compartment. Unbolt the two (2) rear seat bolts that secure the seat to the
vehicle.
2-
Install floor adaptor # XLS-DRAMR02R-01 over the seat brackets. Use the original bolts
to position and secure the adaptor in place. Unbolt the seat belt from the bottom of
the “B” pillar. Attach the seat belt to floor adaptor # XLS-DRAMR02R-01 using a
7/16”x 1” bolt.
3-
Install the
XL-SEAT
onto the floor adaptor. Secure it in place using four (4) 7/16”x 3/4”
flat head bolts.
4-
Proceed with the electrical installation. Follow the instructions found in the attached
document entitled: ELECTRICAL INSTALLATION FOR XL-SEAT.
REMOVE
