ML605 Hardware User Guide
www.xilinx.com
13
UG534
(v1.2.1) January 21, 2010
Detailed Description
1. Virtex-6 XC6VLX240T-1FFG1156 FPGA
A Virtex-6 XC6VLX240T-1FFG1156 FPGA is installed on the embedded development
board.
Keep-Out areas and drill holes are defined around the FPGA to support an Ironwood
Electronics SG-BGA-6046 FPGA socket.
References
See the
Virtex-6 FPGA Data Sheet
.
[Ref 4]
Configuration
The ML605 supports configuration in the following modes:
•
Slave SelectMAP (using Platform Flash XL with the onboard 47 MHz oscillator)
•
Master BPI-Up (using Linear BPI Flash device)
•
JTAG (using the included USB-A to Mini-B cable)
•
JTAG (using System ACE CF and CompactFlash card)
18
Switches
13, 25, 39
a. Power On/Off
Slide switch
39
b. FPGA_PROG_B
pushbutton
active-Low
13
c. System ACE CF Image
Select
4-pole DIP switch (active-High)
25
d. Mode Switch
6-pole DIP switch (active-High)
25
19
FMC - HPC connector
Samtec ASP-134486-01
16 -19
20
FMC - LPC connector
Samtec ASP-134603-01
20
21
Power management
35 - 44
a. PMBus controllers
2 x TI UCD9240PFC
35, 40
b. Voltage regulators
2 x PTD08A020W, 3 x PTD08A010W
36-38, 43,
44
c. 12V power input
connector
6-pin Molex mini-fit connector
39
d. 12V power input
connector
4-pin ATX disk type connector
39
22
System Monitor Interface
connector
2x6 DIP male pin header
34
23
System ACE Error DS30 LED
disable jumper J69
Jumper on = enable LED
Jumper off = disable LED
13
Table 1-1:
ML605 Features
(Cont’d)
Number
Feature Notes
Schematic
Page
