Xiamen Hanin Electronic BIMP B4d Series, User Manual

Page: 35 / 63

35
B4d Series User Manual
3.6.3 Quick Calibration
Users must carry out the calibration under the conditions
below:

The first time to use the printer since
installation;

The first time to use the printer since sensor cleaning;

Reuse the printer when it has not been used for a long time;

Change a new type of media;

Printer cannot recognize the mark;

Huge change of the operating environment;
Calibration method

Carry out the calibration manually.
When printer is ready, press the FEED button for 3 seconds until the status indicator(Green)
flashes twice. Then release the button, and printer will start to do the calibration. When
printer does the calibration under Continuous Media Mode, the calibration is invalid.

Carry out the calibration by printer utility tool.
Please refer to detailed information in “Chapter 6 Printer Utility Tool Instructions”.
Note : After the quick calibration, users could open the printer cover to pull back the
learned paper in avoid of paper wasting.
3.6.4 Print Self-test Page
The self-test checks the printer’s current settings, status and whether the printer has any
problems or not.
1.Printing Manually
1) Make sure the roll is loaded properly.
2) Make sure the top cover of the printer is closed properly. Then turn on the printer.
3) When the printer is ready, press the feed button continuously. As soon as the indicator
flashes (green) once, loosen the button. Then the printer starts to print the self-test
page.
2.Printing by Windows Driver
Program 1) Install the Windows
Driver program.
2)
Set the “Interface” as the type you use.