13
CN3200 Access Point - Installation Guide - G7604 - Release 3.3
These steps set up the CN3200 Dual Band Routing Modem for use. After completing these
configuration steps, the CN3200 Modem will be fully functional and ready for operation.
The CN3200 modem will provide any Internet-ready device the ability to connect to a public
network via both xMax and WiFi using a hardwired connection to either an Ethernet switch/hub or
an external WiFi hotspot connected through the Ethernet port on the CN3200. The switch/hub or
hotspot is not provided and must be purchased separately.
Devices may also be connected to the xMax network through a wired Ethernet connection to the
CN3200 Modem.
For more information, see
Wired Internet Connectivity and Setting Up a WiFi Hotspot
on page 35.
NOTES
This procedure should be completed before installing the CN3200 Modem in a service location.
The setup sequence assumes that the CN3200 Modem device is in factory-default
configuration and has not been previously configured.
IMPORTANT: BEFORE YOU CONTINUE
Antennas or dummy loads
MUST
be connected to the two top
Tx RF
ports.
The CN3200 Dual Band Routing Modem is powered through the Ethernet cable. PoE (Power-over-
Ethernet) is a standardized system which passes electrical power along with data on Ethernet
cabling.
After terminating the Tx RF ports, connect the provided PoE++ Power Supply, as shown:
DO NOT
plug the power cord into the AC outlet until directed.
Private
Network
110-240 VAC,
50-60 Hz
PoE++
Power Supply
DATA OVER
ETHERNET
POWER
plus DATA
CN3200
TERMINATE
BEFORE
POWER UP