XFX MCP55, Installation Manual

Page: 18 / 57

Connectors
The motherboards include common connectors such as FDD, IDE, Serial ATA, USB ports and many
other ports.
Attention:
Disk drives suck as FDD, and IDE uses directional ribbon cables, therefore make sure that the
red line (or dotted red line) is matched with pin 1 on the connector.
FDD Connector: Floppy
The motherboard includes a standard FDD connector, supporting
360K, 729K, 1.2M, 1.44M and 2.88M FDDs
IDE Connector: PIDE
The IDE connector supports Ultra ATA 133/100/66 IDE disk drives. If you install two hard disks, you
must configure the jumpers on the hard disk accordingly. Please refer to you hard disk user guide from
hard disk manufacture for proper jumper configuration.
Front Panel Connector: FP1
The motherboard includes one connector for connecting the front panel switch and LED indicators.
HDD LED Connector (HDD-LED)
This connector is for the hard drive indicator LED to show hard drive activ-
ity.
Reset Switch (RESET)
Reset switch connector for the reset button on the case.
Power LED connector (PWRLED)
Connector for the power LED indictor to show system’s status.
Power Switch Connector (PWRSW)
The is the connector for the power connect for the case. This button will
slow the system to be turned OFF or turned ON.
Floppy PIN 1
PIN 1
PIDE
PWRLED Empty
PWRSW
1
RESET
HD-LED
NC
FP1
16
Chapter 2: Installation Instructions