XEV Y0210, Manual, Page: 59 / 142

51
Overtaking signal
When overtaking, please turn on the
left turn signal first, and then switch
quickly and repeatedly between
turning on and off the high beam to
alert the car in front.
◆
Do not use high beam when driving
at night on the road without center
isolation facilities or center line within
150m from the vehicles in the
opposite direction.
◆
Do not use high beam when
meeting with non-motor vehicles on
narrow bridges or narrow roads
without center isolation facilities or
center lines.
◆
Do not use high beam when turning
through intersections controlled by
traffic lights.
◆
Do not use high beam when the
following vehicle and the preceding
vehicle are driving in close distance in
the same direction when there is no
street light or poor lighting at night, or
when there is fog, rain, snow, sand or
any other low visibility condition.
◆
When crossing sharp turns, slopes,
arched Bridges, crosswalks, or
intersections without traffic lights,
quickly alternate between high and
low beams.
Hazard warning lamp
Charging Instrument&control Lighting Safety Vehicle Start&driving Emergency
The hazard alarm lamp switch is on the
secondary dashboard. When the lamp
is on, the steering lamp will flash, and
indicator on the instrument cluster will
flash.
When the hazard alarm lamp is on, the
steering lamps cannot function.
In case of the following situations, use
hazard alarm lamp to cause other
drivers' attention:
1. The vehicle breaks down and is
unable to run.
2. The vehicle is at the end of traffic
jam.
3.
When b eing towed during an
emergency.
Maintenance Technical information
Warning
Lamp