Xerox WorkCentre 5325, Administrator'S Manual

Page: 22 / 160

Network Configuration
WorkCentre 5300 Series Multifunction Printer
System Administrator Guide 22
TCP/IP
Transmission Control Protocol (TCP) and Internet Protocol (IP) are a two protocols within the Internet
Protocol Suite. IP manages the transmission of messages from computer to computer while TCP
manages the actual end-to-end connections.
Note: You can configure IPv4 settings at the printer control panel or through CentreWare IS. You
can only configure IPv6 through CentreWare IS.
Enabling TCP/IP
Note: By default, TCP/IP is enabled. If you disable TCP/IP, you must enable it at the printer control
panel before you can access CentreWare IS.
1. At the printer control panel, press the Machine Status button, then touch the Tools tab.
2. Touch Connectivity and Network Setup > Protocol Settings .
3. Touch TCP/IP - IP Mode , then touch Change Settings .
4. Touch IPv4 Mode , IPv6 , or Dual Stack to enable both IPv4 and IPv6.
5. Touch Save .
Configuring TCP/IP Settings at the Control Panel
Manually Configuring an IPv4 Network Address
1. At the printer control panel, press the
Machine Status
button, then touch the
Tools
tab.
2. Touch
Connectivity and Network Setup
>
Protocol Settings
.
3. Touch
IPv4 - IP Address Resolution
, and touch
Change Settings
.
4. Touch
Static
, then touch
Save
.
5. Touch
IPv4 - IP Address
, and touch
Change Settings
.
6. Type the static IP address using the touch-screen keypad, and touch
Save
.
7. Touch
IPv4 - Subnet Mask
, and touch
Change Settings
.
8. Type the subnet mask using the touch-screen keypad, and touch
Save
.
9. Touch
IPv4 - Gateway Mask
, and touch
Change Settings
.
10. Type the gateway mask using the touch-screen keypad, and touch
Save
.
Manually Configuring an IPv6 Network Address
1. At the printer control panel, press the
Machine Status
button, then touch the
Tools
tab.
2. Touch
Connectivity and Network Setup
>
Protocol Settings
.
3. Touch
IPv6 Address Manual Configuration
, then touch
Change Settings
.
4. Touch
Enabled
, then touch
Save
.
5. Touch
Manually Configured IPv6 Address
, then touch
Change Settings
.
6. Type the static IP address using the touch-screen keypad, and touch
Save
.
7. Touch
Manually Configured IPv6 Address Prefix
, and touch
Change Settings
.