Versant 80 Press
Customer Expectation & Installation Guide
33
Press Output and Other Equipment
The Press output (prints) should not be run through the printing path of Nuvera® or DocuTech® Production Publishing systems. However,
the prints can be used with the Interposer module.
Nuvera, DocuTech, and other technology output, including preprinted offset shells, should not be run though the printing path of a
Versant® 80 Press.
If you plan to run the Press output through other equipment, including finishing devices such as a coater or laminator, it is recommended
you test the application before committing to the job. Many factors impact the success of running the Press output in other equipment.
Duplex (2-Sided Prints)
Automatic duplex printing can be performed on recommended media up to 13 x 19 in (SRA3 320 x 450 mm/maximum 320 x 482 mm) from
52-300 gsm.
Manual duplex can also be performed on recommended media up to 13 x 19 in (SRA3 320 x 450 mm/maximum 320 x 482 mm) from Tray
5 (Bypass).
As with any printer or copier, duplex performance may not match the performance for single-sided printing or copying. Paper jam rates may
be higher than the rate you will experience for the same throughput material in single-sided mode.
In order to reduce paper jam frequency when duplex printing on stocks heavier than 220 gsm (80 lb. Cover), paper grain should be
perpendicular to the print process direction (i.e. Short Grain).
Transparencies
For optimum system performance and image projection, use Xerox removable stripe transparency materials. These premium transparencies
are specifically designed to provide optimum print quality. Use of other transparencies may cause machine damage and result in excessive
service calls.
Due to the increased thickness of the removable stripe, no more than 100 transparencies should be loaded in a paper tray at one time. The
maximum output stack height should not exceed 100 transparencies.
