Xerox Versant 80 Press, Installation Manual

Page: 11 / 62

Versant 80 Press
Customer Expectation & Installation Guide 7
Electrical Requirements
Electrical Xerox Versant ® 80 Press
Press North America Receptacle:
208–240 VAC, 50/60 Hz,
NEMA 6-20R
Europe: receptacle that mates to the PCE Shark 023-6 plug (shown below)
220 – 240 VAC, 50Hz
Additional electrical required for print server,
feeding / finishing devices.
(Note: HCF, BR Finisher and BR Booklet
Finisher plug directly into press and require
no additional receptacle.)
Nema 5-15R or 5-20R
For detailed information refer to Electrical Requirements .
Power Consumption Xerox Versant ® 80 Press
Voltage XC – 208 - 240 V
XE – 220 - 40 V
Power Consumption XC – 208 – 3.66 kW or less
240 – 4.224 kW or less
XE – 220 – 4.4 kW or less
240 – 4.8 kW or less
Standby Mode 1,400 watts
Warm up Time from Power off ≤ 5 minutes
Feature Specifications
Print Xerox Versant ® 80 Press
* Using Centerline Paper
First Print Out Time
(FPOT)

In “Ready Mode” the FPOT is on average less than 8
sec. for color and less than 10 sec. for B/W.

At initial power on copy/print, the system requires
between 30 and 45 seconds to produce the first print.

Switching from a Color Mode job to a B/W job or the
reverse requires on average between 30-60 seconds.

60 seconds is always needed after a paper jam to
ensure the system is recovered from possible
contamination, and ensure that the image quality is
optimized.
FPOT is measured from the time the Printer starts to the time the trail
edge of the sheet exits the Offset Catch Tray.
Note: If the system is equipped with various types of finishing devices,
the FPOT time will vary depending on the length of the paper path
needed to transport that paper.
Resolution 
2400 x 2400 x 1 dpi** (Print Engine Addressability)

1200x1200 dpi RIP resolution

8 bits per pixel bit depth
**dpi = dots per inch
Halftones Screens supported:
300 dot, 200 line, 175 dot 150 dot, 200 dot, and stochastic