Fax Defaults
System Administrator Guide
6-3
■
14.4 kbps (G3)
■
19.2 kbps
■
28.8 kbps
■
33.6 kbps (Super G3)
Error Correction Mode:
This setting turns Off or On automatic error correction during fax
transmission and reception. The default setting is On.
Fax Send Setup
Transmission Report:
This setting specifies when a fax Transmission Report is printed.
Transmission Reports provide feedback about the fax transmission, such as when it was sent,
call duration, etc. The default setting is Error Only.
■
Always:
A Transmission Report is printed for each fax sent.
■
Never:
A Transmission Report
is not printed for any fax sent.
■
Error Only:
A Transmission Report is only printed when a fax error occurs for one or
more recipients.
Note:
You can override this setting at the control panel.
Report with reduced 1st page:
This setting turns On or Off printing a reduced image of the
first faxed page on the Transmission Report. The default setting is On.
Redial Count:
This setting determines the number of redial attempts the system makes after
encountering a busy signal. The default setting is 3 Times.
Redial Time Interval:
This setting specifies how many minutes the system waits to redial
after encountering a busy signal. The default setting is 3 Minutes.
Auto Resend Policy:
This setting specifies what the system does with fax pages after an
interruption. The default setting is Unsent pages.
■
Unsent pages:
Send pages that were not sent.
■
All pages:
Resend all pages.
Auto Resend Count:
This setting specifies the number of times to restart a fax transmission
after an interruption. The default setting is 3 Times.
Resolution:
This setting determines the fax print resolution. The default setting is
Fine (200 x 200). The following values are supported:
■
Standard (200 x 100)
■
Fine (200 x 200)
■
Super Fine (200 x 400)
Transmission Header:
This setting turns Off or On including the Line Name in the
Transmission Header. The default setting is On.
