Quick Network Install Guide
11
Windows 9x (95/95sr2/98/98se),
Windows 2000, and
Millennium (Me/ME) Networks
Introduction
Your printer can be installed on a Windows 2000 network using one of
three methods:
■
TCP/IP protocol (LPR into Port 9100/AppSocket)
■
Server Message Block (SMB) protocol
■
AppleTalk protocol
Your printer can be installed on a Windows 9x (95/95sr/98/98se)
network or a Millennium (Me/ME) network using the SMB protocol
method.
The
Preliminary Steps
given below must be accomplished for all
printers regardless of the protocol that is being used. Then, the
Quick
Install Steps
will detail the installation based on the protocol used on
your network.
The CentreWare DP program on your Printer Management Software
CD-ROM can also be used to monitor and configure the printer.
Preliminary steps
1.
Print the Configuration Sheet. Details are in this document in
Appendix A: Print the Configuration Sheet
. Retain this page for
reference.
2.
Check the Configuration Sheet and verify that both the desired
protocol and connector are enabled.
3.
Proceed to the Quick Install Steps for your network protocol.
