Quick Network Install Guide
21
OS/2 Warp V4.0 and
OS/2 Warp Connect 3.0
Peer-to-Peer Network
Quick install steps
1.
Print the Configuration Sheet. Details are in this document in
Appendix A: Print the Configuration Sheet
.
2.
Check the Configuration Sheet and verify that both the TCP/IP
protocol and proper connector are enabled on the printer.
3.
Create a new printer to load print drivers. Details for this are
found in the
Advanced Features and Troubleshooting Manual
.
4.
Create a printer share and set its access permissions (sharing and
connecting).
5.
Start LPRPORTD/LPRMON, ping the printer, open EPM and send
a print job to the printer.
6.
Check the print job for print-quality. If print-quality problems
exist, use the print-quality section of your printer’s
Advanced
Features and Troubleshooting Manual
to correct the problem.
7.
If your print job did not print, see the Troubleshooting section for
your operating system in the
Advanced Features and
Troubleshooting Manual
to correct the problem.
