Quick Network Install Guide
7
Windows NT 4.x Network
Introduction
Your printer can be installed on a Windows NT network using one of
two methods:
■
TCP/IP protocol
■
AppleTalk protocol
The
Preliminary Steps
given below must be accomplished for all
printers regardless of the protocol that is being used. Then, the
Quick
Install Steps
will detail the installation based on the protocol used on
your network.
The CentreWare DP program on your Printer Management Software
CD-ROM can also be used to monitor and configure the printer.
Preliminary steps
1.
Print the Configuration Sheet. Details are in this document in
Appendix A: Print the Configuration Sheet
on page 26. Retain this
page for reference.
2.
Check the Configuration Sheet and verify that both the desired
protocol and connector are enabled.
3.
Proceed to the Quick Install Steps for your network protocol.
Quick install steps (TCP/IP protocol)
1.
At the Desktop, right-mouse-click the Network Neighborhood
icon and select
Properties
.
2.
Click on the
Protocols
tab and verify that the TCP/IP protocol has
been loaded.
3.
Select the
Services
tab and verify that
Microsoft TCP/IP Printing
is loaded.
4.
If this software is not present, install it using the documentation
provided by Microsoft. Then return to this document.
5.
Open the
Control Panel
and double-click the
Printers
icon.
