Xerox 490/980 Color Continuous Feed Printing System
Color Calibration Process for v1.1.6 Software
Color Management Guide
5-13
Note
Each test pattern takes about two minutes for the Eye-One iSis to process.
6.
Insert a test pattern into the Eye-One iSis with the solid black bar facing upwards.
7.
After the color data has been successfully processed, remove the test pattern from the Eye-
One iSis and press [
OK
] at the pop-up window.
8.
Select [
Save Data
].
9.
Under the Format drop-down menu, select [
CGATS
].
10. Select [
Save
].
Note
If a duplex system exists, the first file scanned from each engine should be denoted with an
_1.txt at the end of the filename. The second file with a _2.txt, etc.
11. For the filename, type in an appropriate name (i.e. Upstream_1.txt).
12. Select [
Save
] and choose the [
My Documents
] folder.
13. Select [
Clear Data
] and select [
OK
] at the pop-up window.
14. Do one of the following based on whether a simplex or duplex configuration exists:
a.
For a simplex configuration: Repeat steps 6-13 for the remaining two test patterns and
proceed to step 15.
b.
Repeat steps 6-13 for the remaining two test patterns of the upstream printer, and
three test patterns of the downstream printer, then proceed to step 15.
15. At the pop-up window, select [
Close
].
16. Exit the ColorPort Utility Software.
Summary of Contents for Document Centre 480
Page 1: ...Xerox 490 980TM Color Continuous Feed Printing System Color Management Guide 27 October 2008 ...
Page 2: ......
Page 101: ......
