Xerox DocuColor 252, User Manual, Page: 228 / 262

220 Chapter 9 – Reinstalling the Spire CX260
9. A system message may appear requesting you to restart the computer.
a. Exit the Spire CX260 software.
b. Click Yes to restart your computer.
Restoring the Factory Default Configuration
To restore the Factory Default configuration, the operating system must be in
Factory Default mode. See
Verifying the Current Recovery Type on page 217.
1. Exit the Spire CX260 software and wait for the Spire icon to disappear from the
desktop taskbar.
2. Using the tip of a pen or similar object, push the RCVR button on the Spire
CX260.
3. From your Windows-based computer, Macintosh computer, or portable
workstation, connect to the Spire CX260 via the RDC utility. See
Working from
the Remote Desktop Application on page 86.
4. When the RCVR LED (7) illuminates steady orange, go to Start > CX260 >
CX260 Tools > System Backup and Restore > Set Factory Default recovery .
5. When the operating system confirmation message appears, click OK .
6. Push the green On/Off button to restart the Spire CX260.
Norton Ghost copies the files from partition E to partitions C and D. This
process takes approximately 10-15 minutes.
Note: The Spire CX260 default backup configuration is the Last Image
configuration.
Taskbar with Spire icon
Taskbar without Spire icon
Note: If you only want to verify the current recovery type, but do not want
to initiate the recovery process, push the RCVR button again to exit the
recovery mode (LED 7 turns off).
Note: This step is required only for the CX260 basic configuration.