DocuColor 240/250
DocuColor 240/250 Training and Information Guide
153
Replacing the Fuser
This procedure shows you how to remove a used Fuser and replace it with a new
Fuser. The machine will tell you when you need to install a new one. The Fuser
can be recycled so please follow the disposal instructions you receive with the
new cartridge.
1. Make sure the machine has stopped running, and open the Front
Door.
2. Grasp Handle #2 and turn it to the unlocked position.
Warning:
To avoid burns wait at least 5-10 minutes after powering off
the printer to allow the fuser to cool down, and observe
warning labels inside.
3. Carefully pull out the Transfer Module.
4. Grab and lift the Amber-Gold colored handle only, lift and pull up
and out of the Transfer Module.
5. Dispose of the old Fuser as normal office waste or recycle the old
Fuser.
6. Remove the new Fuser from its packaging.
7. Insert the Fuser into the Transfer Module while holding the Amber-
Gold handle.
8. Close the Transfer Module.
9. Turn Handle #2 to the locked position.
10. Close the Front Door.