Xerox DocuColor 2060, Installation Planning Manual

Page: 165 / 218

Defining the printer to the host: TCP/IP attachment
Installation Planning Guide F-3
3. Configure the PSF printer in JES2 or JES3
This section discusses the procedures for configuring the printer
in JES2 or JES3 environments.
Configuring in
JES2
To configure the PSF printer in JES2, follow these steps:
1. Locate the JES2 initialization dataset in the JES2 Startup
JCL Procedure (JES2 PROC). (This is normally kept in
SYS1.PROCLIB, although your system may use a different
library.)
The JES2 PROC has a DD statement (normally
HASPPARM), which points to the initialization dataset. (The
location of this statement is SYS1.PARMLIB(JES2PARM);
however, you should always verify the location on your own
system.)
2. Enter the following required commands in the JES2
initialization dataset to define the PSF functional subsystem
(FSS):
• One FSS statement for each PSF functional subsystem
• One PRTnnnn statement for each functional subsystem
application (FSA) under control of the FSS. (This can also
be specified as PRINTnn or PRINTERn.)
The following table lists the JES2 FSS statement parameters
to be defined.
Table F-1. JES2 FSS statement parameters
Item
description
Default
Source of
value
Range of
acceptable
values
Comments
Your
value
FSS parameters
PROC None PSF Startup
procedure
name/ 1 to 8-character
alphanumeric
string Specifies name of
procedure for starting
this FSS. Different
FSS statements can
refer to the same
startup procedure
AUTOSTOP NO Installation
preferences YES or NO Specifies whether FSS
address space is
stopped automatically
if all FSAs under
control of the FSS are
stopped.