Xerox DocuColor 2060, Troubleshooting Manual, Page: 53 / 60

Resolving printer problems
Troubleshooting Guide 6-5
Tray 4 problems
The following table describes problems associated with tray 4.
Table 6-3. Tray 4 problems
Symptom Probable cause Action
Tray 4 does not feed. No power • Ensure the power cord is plugged in to the
proper wall receptacle (the ground fault
indicator must be plugged in to reset).
• Test the ground fault indicator (GFI):
1. Locate the GFI at the bottom center of
the back cover of tray 4.
2. Check to see if the GFI switch was
tripped. Press and release the RESET
button. Power should be restored to
Tray 4.
Figure 6-1. Tray 4 GFI
• If the actions above do not restore power to
tray 4, or if loss of power to the tray seems to
be excessive, contact your Xerox service
representative.
Printer is not set to feed
from tray 4. At the printer controller, use the set tray
procedure to set up tray 4.