![background image](http://html2.mh-extra.com/html/xerox/docucolor-2060/docucolor-2060_maintenance-manual_3308232020.webp)
Feeder trays
1-2
Guide to Performing Routine Maintenance
Be sure to use the tray weight indicator to specify the correct
weight. This is essential for correct paper handling. For tray 3,
you must also set the paper size (Non Standard or Standard),
and the paper type (Coated or Uncoated).
NOTE: The paper weight you specify using the tray weight
indicator may be a different number than the one specified using
the procedure to set trays at the printer controller. This is
because you must specify weight in grams per square meter
(gsm, or g/m
2
) at the printer, but you can specify weight using
any unit of measurement at the printer controller.
Loading paper trays 1, 2, or 3
To load paper tray 1, 2, or 3:
1. Pull out the tray slowly until it stops.
2. Load the correct size paper into the tray in the correct feeding
orientation. Refer to the orientation labels on each tray. Do
not load materials above the MAX line located on the edge
guide.
NOTE: In all trays that have the same size media, the media
must be loaded in the same orientation (SEF or LEF).
•
Load the paper seam side (the side where the ream of
paper is sealed) down in tray 1 and tray 2.
Figure 1-1. Paper orientation for trays 1 and 2
Summary of Contents for DocuColor 2060
