Xerox DocuColor 2060, Maintenance Manual, Page: 79 / 88

Default settings for the printer engine
Guide to Performing Routine Maintenance 7-27
• If the optional paper tray 4 is connected, a button for tray 4
is displayed under Paper Trays. You may select from any
of the displayed paper weights; 64 to 220 g/m
2
(gsm), and
either coated or uncoated paper. Select the correct paper
type if other than Paper Type A. Refer to the tables above
for the default settings.
5. Touch the Close button to save your selections and return to
the Machine Defaults 2 screen. Exit the Tools mode and run a
few test prints to determine if the curl was reduced to a
satisfactory level.
If there is still too much curl, flip over the stack of paper in the
tray and try running a few prints again.
If curl is still excessive, access the Tools mode again and try
another Paper Type setting. If you are not successful in
reducing the curl, call your service representative.
Touch the Reset button on the Decurler Setup screen to
return to the settings established when you first accessed the
screen.