Xerox B210, Service Manual, Page: 86 / 142

July 2019
4-33 Xerox® B210 Service Manual
REP 4.13
Repairs - Adjustments Initial Release
9. Lift the Pinch Rolls and Paper Guide out of the printer, then remove the Feed Assembly
upper half,
Figure 5 .
Figure 5 Registration Pinch Rolls and Paper Guide
10. Remove the Feed Assembly lower half, then remove the Drive Roll from the lower half,
Figure 6 .
Figure 6 Feed Assembly Lower Half
11. Remove the snap rings and bushing from the Drive Roll Shaft, Figure 7 .
Figure 7 Drive Roll
Replacement
Replacement is the reverse of the removal procedure.
NOTE: Tapered plastic screws and round machine screws are used to hold the cover to the
frame. Make sure that the plastic screws go into plastic components and machine screws go
into the metal frame.
1. Install the Drive Roll in the Feed Assembly lower half, ensure the flat on the bushing
aligns with the flat on the assembly
2. Install the Feed Assembly upper half, install the two Feed Assembly bottom screws, then
route the wires through the frame. Refer to,
Figure 6 in the removal procedure.
Pinch Rolls &
Paper Guide
Upper Half
Drive Roll
Lower Half
Snap Rings Bushing