Xerox 721P85530, Description

Page: 353 / 488

SPECIFYING DYNAMIC JOB DESCRIPTOR ENTRIES (DJDES)
XEROX DOCUPRINT 180 LPS PDL REFERENCE 8-23
Points to note
Note the following when using the BARCODE command:
•
Sequence numbers can range from 0 to 65535, but 0 and
65535 are reserved for system use (refer to the BAR ALI
command in the
DocuPrint 180 LPS Operator Guide and
BARCODE NOSEQ commands in this chapter).
•
At the start of a job, the sequence number is always reset to 1.
It can also be reset when a user-specified ABORT I or an
INPUT processing forced abort was initiated.
•
The READ parameter is not intended to physically enable (or
disable) the barcode reader. It only directs the course of action
taken when a barcode is read when none is expected.
Use BSEQ to either reset the sequence number at the start of a
report (RESET), not reset the sequence number (NORESET),
or recognize the presence of bar codes without specifying
sequence numbers (NOSEQ). The DocuPrint 180 LPS makes
the determination to perform RESET/NORESET/NOSEQ
processing at the start of every report. The start of report for
BSEQ processing includes any DJDE packets specified prior to
any data in the report. Any BSEQ DJDEs specified thereafter
are ignored, including any JDE/JDL DJDEs.
Table 8-14. BSIDE parameter option(s) and definition(s)
Option(s) Definition(s)
ODD Indicates that the system will assign sequence and
presence information assuming that only odd sides
are to be considrered.
The default is ODD.
EVEN Indicates that only even sides will be considered
when assigning sequence and presence information.
If EVEN is coded for a simplex job, the job will contain
no bar code sequence or presence information.
BOTH Indicates that add sides of simplex sheets and both
sides of duplex sheets will be considered in
sequence and presence processing.