Xerox 721P85530, Description

Page: 211 / 488

PRINT FORMAT COMMANDS
XEROX DOCUPRINT 180 LPS PDL REFERENCE 6-45
BTEXT
This parameter supports the PC UI report audit logging feature which
creates an audit log on the UI hard disk. The audit log is initiated and
terminated by including enabling data in the job stream. The PDL/
DJDE command, BTEXT, is implemented primarily to support
barcode audit logging which is not implemented in the DocuPrint
180 LPS. BTEXT report definition parameters are, however, useful
without the installation of a barcode reader. Page definition
parameters, on the other hand, are meaningless without barcode text
or a barcode reader.
Note: DocuPrint 180 LPS does not support the barcode option.
Barcode commands which are encountered by the DocuPrint 180
LPS controller will be gracefully ignored (no syntax errors will be
noted, no messages or operator information pages will be
generated).
Syntax MESSAGE BTEXT = option(s)
Options Table 6-39 lists the parameter option(s) and definition(s).
Table 6-36. BTEXT parameter option(s) and definition(s)
Option(s) Definition(s)
RNA= xxx Report name (maximum of 16 characters). This
keyword is required in the first BTEXT of each report
to be audited. It may only occur once per report. For
clarity in relating the audit reports to SFS reports, this
should be the same value used for job accounting.
This parameter must be present to audit a job or
report.
CJN= sss Customer job number (maximum of 6 digits). For
clarity in relating the audit report to SFS reports, this
should be the same value used for job accounting
DPT= xxx Department name (maximum of 31 characters). For
clarity in relating the audit reports to SFS reports, this
should be the same value used for job accounting.