Printer Settings
Phaser® 6360 Color Laser Printer
4-6
Changing the Power Saver Timeout
To save energy, the printer enters a Power Saver, low-energy consumption mode after a pre-
defined period of time since its last activity. In this mode, most printer electrical systems are
shut down. When a print job is sent to the printer, the printer enters Warmup mode. You can
also warm up the printer by pressing the
OK
button on the control panel.
If you find that the printer is going into Power Saver mode too often and you do not want to
wait while the printer warms up, increase the length of time before the printer goes into Power
Saver mode.
To change the Power Saver Timeout value, use one of the following options:
■
The printer’s control panel
■
CentreWare IS
Using the Control Panel
To change the Power Saver Timeout value on the control panel:
1.
Select
Printer Setup
, and then press the
OK
button.
2.
Select
Printer Controls
, and then press the
OK
button.
3.
To disable Power Saver Timeout, select
Power Saver
, and then change the setting to
Off
.
4.
To set a specific timeout, select
Power Saver Timeout
, and then press the
OK
button.
Press the
Up Arrow
or
Down Arrow
button to scroll to a selected Power Saver Timeout
value. Select a larger value if you want to extend the length of time before the printer goes
into Power Saver mode.
5.
Press the
OK
button.
Using CentreWare IS
To change the Power Saver Timeout value using CentreWare IS:
1.
Launch your web browser.
2.
Enter your printer’s IP address in the browser’s
Address
field (http://xxx.xxx.xxx.xxx).
3.
Click
Properties
.
4.
Select the
General
folder on the left navigation panel, and then click
Warmup
.
5.
Select a value from the
Power Saver Timeout
drop-down list.
6.
Click the
Save Changes
button at the bottom of the page.
