20
EN
ON BOARD
(users present during the charge process)
Put the charger in set-up mode, as described earlier.
A ‘0’ will appear in the display screen. By way of pressing on the ‘mode’ button
it is possible to switch between the green and the red led. Adjust the charger
as per the
green
led
(= factory setting).
After this wait for 10 seconds. A number will now appear in the display screen
which indicates the charge setting
. By way of repeatedly pressing the ‘mode’
button it is possible to enter the required charging setting.
Charge setting
Suggested battery type
GEL, AGM(1)
STANDARD CHARGING VOLTAGE
(factory setting)
OPEN SEMI TRACTION
TRACTION
CALCIUM. AGM(2), SPIRAL
After this wait for 10 seconds.
A ‘t’ will appear in the display screen. Now it is possible to determine if the
optional temperature sensor has been connected. By way of pressing the
‘mode’ button it is once again possible to switch between the green and red
led.
Temperature
sensor
Set the LED to
green
.
present
Temperature
sensor
isn’t
present
Set the LED to
red
.
(factory setting)