33
Razor
32OAC/DC
TIG-MMA
Installation Set Up for AC & MIX ARC TIG Welding:
1. Connect the Tig Torch connector to the negative terminal and tighten it.
2. Insert the torch gas connector into the quick lock gas receptacle.
3. Connect the torch switch remote lead into the torch remote socket.
4. Connect the torch water leads connectors into the quick lock gas receptacles.
5. Connect the Earth Cable connector into the positive terminal and tighten it.
6. Turn on the Water Cooler with the on/off switch on the front panel of the Water Cooler.
7. Connect gas line to Gas Regulator, connect the gas regulator to the Gas Cylinder, open the cylinder valve slowly.
8. Connect the gas line to the quick lock gas inlet connector at the rear of the machine.
Check for gas leaks -
Esseti NZ Ltd nor it's representatives will be responsible for any gas loss.
9. Switch on the machine using the On/Off switch at the rear of the machine.
10. Set the weld parameters using the front panel set procedure on the following page.
AC and MIX ARC TIG Welding Setup and Operation
7.
Connect the regulator to the cylinder,
Connect the gas lead to the regulator.
Set the flow to 8-12 l/min
3. Connect the torch switch lead
to the torch remote receptacle
1. Connect the TIG torch to the
terminal.
2. Insert the torch gas lead connector
into the quick lock gas receptacle.
8.
Connect the gas line to the quick lock
connector at the rear of the machine
9. Turn on the Power source
using the on/off switch at
the rear of the machine
4. Insert the torch water leads connectors
into the quick lock gas receptacles.
6. Turn on the Water Cooler
using the on/off switch on
the front of the Water Cooler
5. Connect the EARTH lead to
the terminal.
10.
Set the weld parameters. See next
page for setup procedure
Summary of Contents for RazorWeld Razor TIG320 ACDC
Page 7: ...7 Electrical Schematic Diagram Razor32OAC DC TIG MMA...
Page 54: ...54 NOTES...
Page 55: ...55 NOTES...
