Xantrex XW-SCP 865-1050, Owner'S Manual

Page: 44 / 76

Configuration
3–14 975-0298-01-01
Using Cascading Parameters
Xanbus-enabled devices are configured one at a time. However, because
devices often have common settings, cascading parameters can simplify and
speed up system configuration. When a parameter is “cascaded,” a newly
configured device setting is applied to all devices of the same device type on
a common AC or DC connection.
For example, if cascading parameters are enabled and a Battery Size (Ah)
parameter is changed on the inverter/charger setup menu, the same battery
size setting is applied to other inverter/chargers that share the same DC
connection in the system.
To enable or disable cascading parameters:
1. On the System Settings menu, with Cascading highlighted, press Enter.
2. Use the up arrow or down arrow button to change the current setting—
“Enabled” or “Disabled.”
3. Press Enter to select the new setting.
When configuring the network-managed power system with cascading
parameters enabled, you should verify that the configurations have been
cascaded correctly to other devices. Communication errors may cause
parameters to revert to their original values or generate a warning message
on the System Control Panel screen.
Viewing Device Information
The Device Info screen shows the model number, silicon chip serial number
and firmware revision for each Xanbus-enabled device. You cannot select or
change any information on this screen.
To view device information:
1. On the System Settings menu, with View Device Info highlighted, press
Enter.
The Device Info screen appears.
Device Info
00000DB22578
865-1000
1.00.00