Xantrex XW-SCP 865-1050, Owner'S Manual

Page: 16 / 76

Installation
2–2 975-0298-01-01
Installing the XW System Control Panel
The XW System Control Panel is designed to be wall mounted (see
“Mounting the System Control Panel” on page 2–11), and requires no
connections other than Xanbus network cables or a terminator plugged into
the back of the unit.
Because you cannot access the System Control Panel network inputs once
the unit is mounted, the Xanbus cables must be routed through the wall
and connected before securing the System Control Panel.
Materials and Tools Required
The following materials and tools are required to complete the
installation:
p
Mounting template sticker (supplied)
p
Mounting plate (supplied)
p
Mounting bracket (supplied)
p
Four #6 screws (supplied)
p
Two #8 screws (supplied)
p
Cable clamps or hardware fasteners
p
Xanbus network cables or equivalent (CAT 5 or CAT 5e cable with
RJ-45 connectors wired to T568A standard. One 7 foot/2.1 meter
cable is supplied)
p
Two network terminators (one male terminator is supplied with each
Xanbus-enabled device, but termination requirements vary with
network layout)
p
Phillips head screwdriver
p
Jigsaw or small keyhole saw
p
Power drill with 1/8" bit (optional)
Choosing a Location
Choose a location that allows unobstructed access to the System Control
Panel screen and buttons.
The location should be indoors, dry, and free from corrosive or explosive
fumes.