Xantrex PathMaker, Owner'S Manual

Page: 5 / 20

5
Setup and Operation
See Page 14
CONNECT THE SYSTEM
NEGATIVE (ground) TO
THIS TERMINAL LAST.
(Use #14 AWG wire or larger)
Factory Installed
Optional Remote
See Page 13
*Multiply voltage values times 2
for use on 24 V systems.
High Voltage Disconnect*
Above this voltage, the power
switch(es) are disabled. The
default voltage setting is 15.0 V. The
red “High Voltage Disconnect”
light is on solid when active.
Low Voltage
Disconnect*
Below this voltage, the
PathMaker power switch(es)
is(are) disabled (the batteries
are not connected together).
The default voltage is set at
13.0 V. The yellow “disabled”
light will be lit whenever the
batteries level falls below the
set point.
Connect Voltage*
Above this voltage the PathMaker
power switch(es) are enabled: thus the
batteries are in parallel for charging.
The default voltage setting is 13.3 V.
The green “connected” light is on
whenever the banks are connected.
(Light may flicker below 12.6 V.)
Adjustments
Default settings are at the
12 o’clock position.
Negative