Xantrex 817-1000, Owner'S Manual

Page: 76 / 82

62 Freedom X Owner’s Guide
Troubleshooting Reference
No output voltage is shown in the LCD
screen but the green status LED for Battery
mode is illuminated. GFCI (when installed) has tripped or
supplementary breaker has tripped.
Circuit breaker on the AC load panel or
AC output disconnect has tripped.
Battery voltage is too low (depending
on setting, see “Operating Limits” on
page 54) to start inverting. LCD screen
may show DC voltage as
 .
Check load and reset the GFCI or supplementary breaker.
Reset the circuit breaker or check the AC output disconnect
circuits.
Check DC connections and cable.
Recharge battery.
No output voltage is shown in the LCD
screen and neither of the green status LEDs
(for Grid mode and Battery mode) is
illuminated. AC shore power is not available or out
of operating range and the inverter is
OFF. • Check AC shore power.
• Turn the inverter ON.
AC shore power is not available and the
inverter is OFF due to a shutdown for
more than 30 seconds. • Check AC shore power and battery voltage.
• Turn the inverter ON and look at the LCD screen for any
error code.
• See Table 6, “Error Codes Displayed on the LCD Screen”
on page 58.
No output voltage. The status LED is not
lighting up. Ignition lock (ACC) signal is not
present. If the ignition control feature is in use, ensure the vehicle’s
ignition is On and the ignition control switch on the front of the
Freedom X 1000 unit is On (|).
Table 7 Troubleshooting Reference
Problem Possible Cause Solution
Freedom X Series INV Owners Guide.book Page 62 Tuesday, June 27, 2017 4:10 PM