25
How To Change The Charger Socket
In order to swap out the charging socket, first you must remove the 4 bolts that attach the
seat post to deck and 2 bolts on deck up front. Remove foot deck, if bolts get stripped you
need to drill off the heads using 1/4" drill bit, or use vise-scrimps. Locate the charging
socket mounted into frame; follow the wires back to a silver box. You'll see a white
connector to disconnect the wires to charger socket. Unscrew the nut on the inside
holding the socket to frame. Take something small like a paper clip and straighten and
poke down inside the white connector to release gold pin lock and pull wire out from
connector. Make note of which wire went into which connector holes. Remove socket from
scooter, and install new socket back thru hole. Install nut to secure socket onto frame.
Then bend out locking tabs on gold pins and reinsert into connector. (Red on Red/Black
on Black). and connect into silver box. Plug in charger into wall and a green light should
appear on charger. Next plug into scooter, charger should turn red when connections are
correct. If not re-post on ticket so we can help you, and if it is red reattach foot deck. Let
unit charge for 8 hrs.
How to Install/Replace Throttle
Open the footplate. Run the new throttle wires down to the battery compartment. Find the
white connector on th
e controller marked “______”. Disconnect this white connector. Mark
the color of the wires on the white connector so you can insert the new wires in the correct
place. Look down inside the white connector that goes to the throttle, you will see metal
pins. The pins are held in place by a small tab that bends outward. Reach inside the front
of the connector with a dental pick or jeweler
’s screwdriver and bend the tab in then pull
the metal pin out the back of the connector. Do this for the other wires. Reinsert the new
wires into the white connectors in the correct place. Now remove the old throttle and wires,
mount the new throttle onto the handlebars, and tighten the setscrew. Install the footplate
and you should be good to ride.
How To Checking Wiring
Please check the wires in your battery and controller area. Give each wire at the
connection a firm but gentle tug pulling away from the connection. Look for any loose,
bare, blackened, broken, or disconnected wires.
1. Check the wires at the rear of the charging socket.
2. Check the wires at the rear of the fuse holder.
3. Check all fuses.
4. Check the wires that connect the batteries together.
5. Check the connections on the controller.
