7
7
Follow the steps in this section to install the SpectroProofer in your printer.
Before using the SpectroProofer for the first time, you must also initialize it
as described on page 19.
Unpacking and Assembly
1. Unpack the SpectroProofer and make sure you have all the parts shown
below:
Setting Up the
SpectroProofer
Note:
The 44" model is shown.
These instructions also
apply to the 24" model.
Save the original box and
packing materials in case
you need to ship the
equipment.
SpectroProofer
main unit
Backing plates
(24" kit)
Backing plates
(44" kit)
Mounting rails, bolts, and Allen wrench
Spectrophotometer
(ILS20EP or ILS20EPUV)
Calibration tile
and holder
Power cord
(varies by region)
USB cable
Cable hooks
OR
Calibration
strip
Summary of Contents for Stylus Pro 7900
Page 1: ...Setup and Maintenance...
Page 4: ...4 4 Contents...
Page 6: ...6 6 Introduction...
Page 20: ...20 20 Setting Up the SpectroProofer...
