-
Always check that the VPS is properly positioned according to different wea-
ther/environmental conditions and/or the above-mentioned recommendations
for use.
-
We recommend using the VPS only and solely together with the approved
standard visor, which has a transmittance value greater than 80%.
-
The VPS does not replace the protection guaranteed by the visor.
-
Always make sure that the VPS is clean and that it is operating properly in
order to avoid scratches and/or anomalous wear on it every time it is acti-
vated.
-
As for VPS and visor maintenance and cleaning operations, please refer to the
appropriate section in the helmet user’s manual.
-
The VPS scratch resistant/fog-resistant treatment highly reduces fogging.
Protracted periods of adverse weather and/or environmental conditions
might cause fogging and/or formation of condensation on the VPS, which
entails a reduction of visibility and/or sharpness of vision: in this case, deac-
tivate the VPS.
-
In case of rain, the direct contact of raindrops with the scratch resistant/fog-
resistant treated VPS quickly reduces sharpness of vision, thus causing scar-
ce visibility: in this case, deactivate the VPS.
-
The special VPS fog-resistant treatment is usually sensitive to high tempera-
tures or heat sources. In this case, contaminations caused by contact with
other materials might occur. These contaminations will cause marks and
stains to develop. In these cases (e.g. when the helmet is kept in the top
case on hot days), it is recommended to make sure the visor is not touching
other materials.
6.
VPS Disassembly
To remove the sun screen from the helmet, open the visor completely and lower the
VPS by rotating the side slider completely upwards (Fig. 8B).
Hold the left lateral part of the sun screen and pull it toward the outside of the hel-
met (Fig. 9).
Repeat the same operation on the right side of the helmet.
7.
VPS Assembly
To assemble the sun screen on the helmet, open the visor completely and push the
side slider completely upwards (Fig. 8B).
Insert the sun screen left end into the left side guide until the grip pawl is hooked in
shell housing (Fig. 9).
Repeat the same operation on the right side of the helmet.
WARNING
-
Make sure the VPS operates correctly by moving the left side slider dow-
nwards (Fig. 8A) and upwards (Fig. 8B) until you hear the clicks meaning that
it enters the relevant positions. If necessary, repeat the above-mentioned
steps.
-
If the VPS opening/closing mechanisms are not working properly or if such
mechanisms get damaged, please contact a X-Lite authorized dealer.
18
Summary of Contents for X-661
