DMX Parameters
The Master channel block controls overall fixture function and final size and position of the projection area.
The Master Mode channel is used to enable or disable the fixture, and to switch the fixture between external input and builder modes.
In Fixture Disabled mode, the fixture is active but will not project any content. This mode can be used to immediately stop all output directly from the console.
External Input mode applies to fixtures equipped with an ILDA input, and in this mode the signal presented at that input is directly displayed by the fixture. In
this mode the external input signal is subject to the Master size, position, and intensity controls.
In Builder mode, the fixture’s Builder capabilities are enabled, and the fixture will project the content generated by the Bu
ilder(s).
An * underneath the channel number indicates that this value must be NON ZERO to get laser output
Master - 6 channels
Channel 8/16 Bit Function
Values
1
8 bit
Enable
0-3
4-7
8-11
12-15
16-255
*
Fixture Disabled
External input
Reserved
Builders Enabled
Reserved
2
8 bit
Intensity
0-255
*
0-100%
3
8 bit
X Scale
0-127
128
129-255
100% - 0%
0
0 - 100% Inverted
4
8 bit
Y Scale
0-127
128
129-255
100% - 0%
0
0 - 100% Inverted
5
8 bit
X Offset
0
1-127
128
129-255
Center
Left Offset
Center
Right offset
6
8 bit
Y Offset
0
1-127
128
129-255
Center
Downward Offset
Center
Upwards offset
Summary of Contents for SkyWriter HPX M-5
Page 20: ...20 etherStop system examples...
