24
Control Source
Sets the control source to Manual, DMX or Art-Net
DMX Timeout (ms)
The DMX timeout setting in milliseconds. Default is 100
Art-Net timeout (ms)
The Art-Net timeout setting in milliseconds. Default is 2000
Load Defaults
Resets the system to the factory defined default settings
About
Important information about your system such as the model of laser, serial
number of the Mercury interface and MAC address of the system
The DMX and Art-Net timeouts should be set to the minimum value that provides reliable operation.
The system requires a continuous control signal to maintain output, and the loss of that control signal
should result in termination of output as soon as possible, with the understanding that there is a
minimum time required for reception of new control packets.
DMX Menu
The DMX menu allows you to set the projector’s DMX receiving charac
teristics, such as:
Address
The starting DMX address of the projector
Packet Threshold
The packet threshold for receiving DMX, default is 30
Network Menu
This menu is where you access the network settings of this projector.
IP Mode
Set the IP mode, at this time the only option is Static IP but this will likely
change in a future release
Static IP
Sets the static IP, the default is 10.0.0.1
Subnet
Sets the subnet, the default is 255.0.0.0
Art-Net Menu
This is where the Art-Net specific settings of the projector are accessed.
Mode
Sets the Art-Net mode as enabled or disabled
Universe
Sets the Art-Net Universe the projector responds to
Poll Reply Mode
Sets the poll reply mode, available options are:
1.
Limited broadcast (default)
2.
Unicast
3.
As Polled
4.
Broadcast
Packet Threshold
Sets the packet threshold, the default is 4
Summary of Contents for SkyWriter HPX M-5
Page 20: ...20 etherStop system examples...
