27
Manual Operation Menu
The manual operation menu allows you to select the manual operation mode of the laser, typically used
to enable ILDA input without the use of DMX or Art-Net. Available modes are:
Fixture Disabled
Disables the laser projector from accepting any control inputs
Builders Enabled
Not yet enabled
Preset Mode
Not yet enabled
External Input
Allows signal input from an external source, such as ILDA or FB4 (if
equipped)
Mercury Menu
This menu grants access to some of the control parameters of the Mercury laser engine. Do not adjust
these settings unless directed to by an X-Laser technician.
Content Menu
This menu allows you to see what content packs you have installed, if any, and to install new content
packs as needed. The projector can store 2 separate content packs.
To install a new content pack, insert a USB drive into the USB port on the laser that has an X-Laser
content file (*.XLC) on it, select content pack 1 or 2, then select Install and follow the on screen prompts.
Restoring settings
In rare cases, improper or corrupted settings may prevent the system from starting correctly or may
cause other undesired operation. In this case, the default settings may be restored by holding the back
key down while the laser powers on. Keep the back key pressed until the two status LEDs next to
the LCD turn green and the system status screen is displayed, then release it.
Summary of Contents for SkyWriter HPX M-5
Page 20: ...20 etherStop system examples...
