11
Power Variations
Laser systems often exhibit minor variations in power level between units, especially between systems
of different ages. X-Laser systems are built to match from unit to unit within a small tolerance that is
usually not noticeable. Variations within that tolerance are not considered a defect, even if they may be
noticeable in certain applications. Contact X-Laser before purchasing if you require more closely
matched systems.
General Guidelines for Safe Laser Use
This product is a powerful laser device intended to be operated by professionals. The major concern
with professional laser systems is to avoid human contact with the laser beam and to create a safe area
where patrons and staff can enjoy your light show. Please observe the following guidelines when using
your X-Laser product:
Safe Zoning
Laser effects should only be projected in areas away from people and flammable materials and free of
surfaces that may reflect laser beams towards people. People should be prevented from entering those
projection zones at all times. If at any point a person enters the projection zone or for any reason any
laser leaves the projection zone the laser display should be immediate terminated.
Prevent Mishaps
As a laser light show operator you have a responsibility to reasonably foresee circumstances where
conditions could present a safety risk to people. This means that you must make sure all laser units are
properly aimed via your show programming and securely mounted to prevent shifting during operation,
physically blocked to prevent radiation spill or reflection into safe areas, and securely mounted. To
ensure that these conditions are met properly, trained employees should be the only ones rigging or
operating X-Laser products.
Means of Termination
Always provide primary and backup means of terminating the laser output in case of emergency. For
example, DMX control as well as a remote etherStop pendant for the Skywriter HPX series. Always test
both primary and backup means of termination before every performance.
Warning: DMX distribution or network control e
quipment that implements a “last look hold” feature
is not a reliable means of termination. Such equipment may continue to provide a control signal that
causes laser emission after a termination command from or even the total failure of the main control
system.
Service and Maintenance
Because there are no user serviceable parts inside of this product, the outer case should never be
opened by the user. To ensure proper safe operation in demonstrations and performances, immediately
discontinue use of this product if you notice or suspect that any part of the laser is not functioning
properly. After any repair, service, or modification, this product must be certified by the manufacturer
to comply with US Federal requirements for laser demonstration equipment. In case of any malfunction,
Summary of Contents for SkyWriter HPX M-5
Page 20: ...20 etherStop system examples...
