Technical Support: [email protected] US: +1 866 677 0053 EU: +44 (0) 1793 230 343
10
OPTIONAL DEVICE CONNECTION, INTERF
ACE DEVICE, BASIC & REMOTE CONTROL OPERA
TION
7vi. Interface Device
9. Remote Control
Handset Operation
8. Basic Operation
For connection of local line level audio sources
(such as MP3 player, multiroom audio system, laptop/
desktop, smartphone/tablet, mixer, microphone etc)
connect a 3.5mm mini jack from the audio source to the
L/R port of the AMP-001-010
To connect stereo speakers directly to the AMP-
001-010, insert evenly stripped, good quality copper
cable of adequate gauge into the SPEAKER spring
terminal connections of the AMP-001-010 with care
taken to insert wires into correct spring clips based on
audio signal polarity (+/+, -/-).
Ensure plastic insulation is undamaged and cable is
untangled, without bends or kinks that may interfere with
transmission.
Attention:
Maximum output available 25w per
channel
For increased bass range, an active subwoofer can
be connected to the SUB OUT port of the AMP-001-010
For additional amplification, the AMP-001-010
can be connected to an external power amplifier or AV
Receiver (AVR) via the stereo AUDIO OUT ports.
Attention:
In such cases where an AVR is
used, the SUB OUT of the AMP-001-010 should
be connected to the SUB Input of the AVR and
a subwoofer connected to the AVR. Likewise,
speakers should be connected directly to the AVR
rather than the spring terminal connectors of the
AMP-001-010.
Using the Audio Pre-Out you can connect the AMP to
a multi-room audio amplifier system or seperate power
amplifier, and expand beyond a basic stereo pair.
The AMP-001-010 can be controlled locally via the front
panel or remotely using the handset provided or an
RS232 third party control system.
Turn on the AMP-001-010 using the POWER switch
on the front panel – LED will indicate power status.
Select the AUDIO SOURCE by pressing the SELECT
button – LED will indicate selection
Toggle standby mode to power down unit when not
in use.
Toggle mute function temporarily disables audio
output
Bass Control button, enable/disable internal cross
over to route bass signals to sub pre-out or main speaker
output.
Source selection to output audio from the main
HDBaseT input, local input jack or ARC from locally
connected TV.
Attention:
TV must have ARC function and be
connected to the relevant HDMI port
Increase/decrease main speaker volume. This does
not control the line level pre-out, this is a fixed output.
Adjust output level of subwoofer pre-out port.
EQ selection buttons to equalize audio signal
depending on your taste.
1
2
3
4
1
2
3
4
5
6
7
1
4
5
6
7
2
3
1
2
7v. Optional Device
Connection
