Würth RL 2-14, User Manual

Page: 88 / 100

Würth RL 2-14
36
Accuracy Adjustment
en
Adjusting the Y-axis step-
by-step
Exiting adjustment mode
step-by-step
Press and hold the Automatic/Manual Mode button for 3 seconds to save and exit Adjustment Mode.
The X-axis LED and Y-axis LED flash alternately three times, then the RL 2-14 shuts off.
)
Pressing the Power button at any time while in Adjustment Mode will exit the mode without saving changes.
Step Description
1. Press the Up and Down Arrow buttons to increment the laser beam up and down. Each increment is
indicated by a flash of the Y-axis LED and a beep from the audio indicator.
2. Continue to press the Up and Down Arrow buttons and monitor the spot until the RL 2-14 is within its
specified range.
)
Five steps are equal to 10 arc seconds of change, or approximately 1.5 mm at 30 m
(1/16" at 100’).
3. Press the Automatic/Manual Mode button to switch back to the X-axis if desired.