Würth RL 2-14, User Manual

Page: 87 / 100

Würth RL 2-14
35
Accuracy Adjustment
en
The following sequence of LED behaviour occurs:
• The X-axis and the Y-axis LEDs flash alternately three times.
• The X-axis LED flashes three times, then flashes slowly until level. When the RL 2-14 is level, the X-axis LED is
on, but does not flash.
• The Y-axis LED is off.
Adjusting the X-axis step-
by-step
The following sequence of LED behaviour occurs:
• The X-axis and the Y-axis LEDs flash alternately three times.
• The Y-axis LED flashes three times, then flashes slowly until level. When the RL 2-14 is level, the Y-axis LED is
on, but does not flash.
• The X-axis LED is off.
Step Description
1. Press the Up and Down Arrow buttons to increment the laser beam up and down. Each increment is
indicated by a flash of the X-axis LED and a beep from the audio indicator.
2. Continue to press the Up and Down Arrow buttons and monitor the spot until the RL 2-14 is within its
specified range.
)
Five steps are equal to 10 arc seconds of change, or approximately 1.5 mm at 30 m
(1/16" at 100’).
3. Press the Automatic/Manual Mode button to switch to the Y-axis.