wtw Turb 550, Operating Manual

Page: 31 / 54

Operation
31
4.4 Configuring the instrument
4.4.1 Changing settings
You can perform the following settings:
l Date (YYYY/MM/DD)
l Time (min/sec)
l Calibration interval (1 - 99 days)
After the set calibration interval expires, the Cal message
appears on the display until the measuring instrument has
been recalibrated).
l Print function (on or off)
If the print function has been set up, measured values that
have been confirmed by the
key are output on the
RS232 interface (to a connected printer or PC).
l Baud rate (1200, 2400, 4800, 9600 - only if the print func-
tion is active)
The settings remain stored in the instrument.
Note
Settings are made in this measuring instrument following a
compelled guidance. If you have called up the setting func-
tion once, you can only leave this function if you have run
through all the settings one after the other and confirmed
this by pressing the
key. Following the last possible
setting, the instrument returns to its normal measuring
mode. You can switch off the instrument only after you have
left the setting function.
Making settings If you want to make any settings, proceed as follows:
1 Press the and keys at the same time. The Year
message and the set up year, e.g. 1999, appears