6-18
Configuration Options
To enable/disable the Automated Mode, go to the System Parameters menu (see
Section 6.2,) and then set the “Automated Mode” option to “On”. When Automated
Mode is enabled, VMR/NPS functions will change as follows:
1.
All Password Security Suppressed:
When a user attempts to access command
mode, the password prompt will not be displayed at either the Setup Port or
Network Port. Unless specifically restricted by the IP Security Function, all
users will be allowed to access both switching and configuration functions, and
all commands will be immediately accepted without the requirement to enter a
password.
2.
Status Screen Suppressed:
The plug status screen will not be automatically
displayed after commands are successfully executed. Note however, that the /S
command can still be invoked to display the status screen as needed.
3.
“Sure?” Prompt Suppressed:
All commands are executed without prompting for
user confirmation.
4.
Error Messages Suppressed:
Most error messages will be suppressed. Note
however, that an error message will still be generated if commands are invoked
using invalid formats or arguments.
All other status display and configuration commands will still function as normal.
