17-9
Command Reference Guide
/BOOT Initiate Boot Cycle
Initiates a boot cycle at the selected plug(s) or Plug Group(s). When a Boot cycle is
performed, the VMR/NPS will first switch the selected plug(s) Off, then pause for the
user-defined Boot/Sequence Delay Period, then switch the plug(s) back on. The /BOOT
command can also be entered as /BO.
Notes:
• When this command is invoked in Administrator Mode or SuperUser Mode, it
can be applied to all VMR/NPS plugs and Plug Groups. When this command
is invoked in User Mode, it can only be applied to the plugs and/or Plug
Groups that have been enabled for the account.
• When the /BOOT command is used to reboot more than one plug, the Boot/
Sequence Delay Periods will be applied as described in Section 6.6.1.
Availability:
Administrator, SuperUser, User
Format:
/BOOT <s>[,Y]
[Enter]
or
/BO <s>
[Enter]
Where:
s
The number or name of the plug(s) or Plug Group(s) that you intend to
boot. To apply the command to several plugs, enter a plus sign (+)
between each plug number. To apply the command to a range of plugs,
enter the numbers for the first and last plugs in the range, separated by a
colon character (:). To apply the command to all plugs allowed by your
account, enter an asterisk character (*).
,Y
(Optional) Suppresses the command confirmation prompt.
Example:
Assume that your account allows access to Plug A2 and Plug A3. To initiate a boot
cycle at Plugs A2 and A3, without displaying the optional command confirmation
prompt, invoke either of the following command lines:
/BOOT A2+A3,Y
[Enter]
or
/BO A2+A3,Y
[Enter]
