WTC Technitron T2050, Description And Instructions

Page: 13 / 61

49@CgYdSXUc
DUSX^Ydb_^D" % GU\T3_^db_\ FUbcY_^F! !Q^TF! !1 )
'! "$$
If DIP 2 is open, then energizing FS1 will run schedule 1. FS2 will
run schedule 2. FS3 will run schedule 3. FS4 runs the schedule
selected on the Data Entry Panel. To select a schedule, press
E
underneath the Sequence column of the DEP until the center row
LED light is next to the Schedule instruction. Press the DATA
W
and
E
keys to change the numeric display value until you reach
the desired schedule number (1 – 60).
',33UHVVXUH6ZLWFKRU6HFRQG6WDJHZLWK9
CLOSED = Pressure switch
OPEN = Second stage.
If running V1.01 firmware and DIP 3 is in the closed (PRESSURE
SWITCH) position, the schedule will execute the SQUEEZE
DELAY and SQUEEZE instructions, then wait until the PS/SS
input is made before executing any more instructions. After the
sequence is initiated, the pilot may be removed and the sequence
will still run to completion. If the pressure switch is not made
after five seconds, the message P_S will be displayed on the
DEP’s numeric display.
If DIP 3 is open (second stage position), the schedule will execute
the SQUEEZE DELAY and SQUEEZE instructions, then wait
until the PS/SS input is made before executing any more
instructions. The guns will open and the sequence will stop if the
pilot is removed before the PS/SS input is made. If the pressure
switch is not made after five seconds, the message S_S will be
displayed on the data entry panel numeric display.
',33UHVVXUHVZLWFKRU6HFRQG6WDJHZLWK9$
2SWLRQIODJVHW
CLOSED = Reset Steppers
OPEN = Second stage.
If running V1.01A and DIP 3 is closed (Reset Steppers position)
and the control is in program mode, when input PS/SS it true, the
stepper programs will be reset. The display will read RES,
indicating the stepper programs are all reset.