9
X
Pac
ATTENTION!
To avoid injury, lock the cordless screwdri-
ver before connecting the
XPac
.
Insert the cordless screwdriver into the locking
ring of the
XPac
.
Before using the
XPac
, check the condition of the tool for any damage – for example oil leaka-
ge or loose components. Such damage could cause severe physical injuries during use.
Defective components or other damage must be repaired or replaced by qualified personnel.
Make sure that the XPac is always placed on a non-slip surface, stored safely and cannot fall
down
Make sure that the Power Pack
XPac
is set up in a work area that is free from heat sources
(max. 50 °C/ 120 °F), and free from corrosive liquids, greases and oils.
ATTENTION! The drill chuck must never be opened or closed with the driven
cordless screwdriver!
3.1 Connecting and adjusting the XPac
The
XPac
is delivered as standard without a cordless screwdriver.
Use a commercially available cordless screwdriver to work with the
XPac
.
However, the device should have a minimum torque of 12.5 Nm.
Pre-mount the torque arm on the
XPac
.
Tighten the drill chuck
by hand
.
3
Abb. 3.1.a
Abb. 3.1.b
Abb. 3.1.c
Abb. 3.1.d
