17
16
High pressure cleaner WG603E WG604E WG605E
automatically, when using foam nozzle, rotary
brush, fixed brush, and patio cleaner (yes)
3. Rotate the regulator cap to adjust foam
amount.
cleaning vertical walls
1. For best results first dissolve dirt by
applying a detergent mixed with water to
the surface while the surface is still dry.
2. Allow the detergent to soak into the
surface for 1-3 minutes but do not let the
detergent dry.
3. Start from the bottom of the wall using
the high pressure rotor (turbo) nozzle at a
minimum distance of 30cm and work in the
upward direction.
4. Do not let the rinse water flow into
unwashed areas.
5. If working on a large section of wall divide
the wall into sections to be cleaned.
6. On some walls high pressure cleaning
using the rotor (turbo) nozzle might not be
the best solution for cleaning dirt especially
if the surface is painted or has delicate
parts it may get damaged. In that case
a suitable brush may be use instead to
remove dirt.
Wood and Vinyl decks (lances)
1. Divide your work area into sections and
clean each section individually for best
results
2. Rinse at high pressure using the Standard
adjustable lance keeping the tip of the
nozzle at least 15-25cm away from the
surface. If using the standard turbo lance
with direct spray increase the distance
from the surface.
Note:
If your deck is made of a softer wood
increase the minimum distance from the
nozzle tip.
cement patios, stone, and brick (lances)
1. Rinse at high pressure in a sweeping motion
while keeping the nozzle tip approximately
7-15 cm away from the surface.
2. Increase the distance if using the direct
spray from the standard turbo lance or if
the patio slabs have damaged grouting or
use sand.
Wood and Vinyl decks, cement patios,
Stone, and brick (patio cleaner WG604e
WG605e only)
1. Attach patio cleaner to extension lance.
2. If using detergent fill up detergent tank and
regulate detergent concentration using
regulator cap.
3. Adjust water pressure on patio cleaner.
Higher pressure is suited for brick, stone,
and concrete and lower pressure is suited
for wood.
4. Divide your work area into sections and
clean each section for best results. Using
patio cleaner make sweeping strokes to
clean a section then move on.
5. If there is excess detergent residue rinse off
with standard adjustable lance set to fan
spray after.
cars, boats and motorcycles
to achieve best results clean one side at
a time.
1. Apply foam using the foam nozzle to one
side and then rinse it off using the standard
adjustable lance in a sweeping motion
2. Maintain a distance of at least 20cm away
from the cleaning surface.
3. If using a direct spray from the standard
turbo lance, maintain a further distance.
4. Fixed brush and rotary brush may also be
used for cleaning of vehicle
5. Wipe the surface dry using an appropriate
cloth for a highly polished finish and shine
WARNING:
Never clean the engine or
motor using this product
Note:
Use of the foam nozzle requires that
the detergent tank contains liquid detergent.
The regulator cap on the detergent tank
may be rotated to adjust concentration of
detergent.
pipes
1. Using pipe cleaner angle pipe cleaner head
down the pipe and press the trigger.
2. Move the pipe cleaner in up and down
motions as you go down the pipe to clean
the sides thoroughly.
3. Work slowly to avoid pipe water backup
and splashing if there is blockage that has
not yet been dislodged.
