17
16
High pressure cleaner WG603E WG604E WG605E
or water tank instead of a water supply main.
With the hose inserted into the bucket or water
tank, the self priming mechanism will draw
water directly from the bucket or tank.
Note: Pay close attention to the amount of
water in the bucket or water tank to ensure
that there is an adequate supply of water to
avoid running the pump dry.
connection to the power supply
1. Check the voltage. The voltage must
comply with the information on the rating
label at the beginning of this manual.
2. Make sure that the on/off switch on the
front of machine is in the OFF position.
3. Connect the plug with a suitable socket or
extension cord.
your product is now fully assembled and
ready for use.
The metal gun is equipped with a trigger lock
to prevent accidental activation.
Use the trigger lock when the washer is not in
use, when it is being left unattended, or when
setting the product down to avoid accidental
operation. (See Fig. T)
1. Activate the trigger lock by pressing the
lock button located closest to the trigger on
the bottom of the grip.
2. Deactivate the trigger lock by pressing the
unlock button located further back on the
bottom of the grip to start operation again.
testing the machine for the first time.
1. Fully assemble the product and attach
lance.
2. Connect water supply hose to product.
3. Turn water supply ON.
4. Make sure the on/off switch located at the
front of the machine is on “off”.
5. Insert the plug into a correct voltage power
outlet/socket.
6. Turn the on/off switch to “on”.
7. Deactivate the trigger lock by pressing the
unlock button.
8. Direct the nozzle away from yourself and
others.
9. Hold the metal trigger gun with both hands
firmly.
10. Press the trigger, a water jet sprays out of
the nozzle.
12. Release the trigger to stop the spray.
13. Activate the trigger lock by pressing the
lock button to lock the trigger into its off
position.
14.Turn the on/off switch to “OFF” position.
15.Turn water supply OFF.
General operation
• Before each use check the product, its
power cord, plug and accessories for
damage. Do not use if the product if
damaged or shows signs of wear.
• Double check that accessories are properly
attached.
• Always hold the product by the metal
trigger gun and lance, never by the nozzle.
• Check to make sure that the air vents
located on the back of the product are
unobstructed and clear. Clean them if
necessary with a soft brush and or remove
large blockage. Blocked air vents can cause
overheating and damage the product.
operation
1. Assemble the machine as described in
manual and switch it “on”
2. Hold the metal trigger gun with both hands
3. Direct the nozzle of your chosen attachment
away from yourself and others towards the
surface to be cleaned.
4. Press the trigger and direct the water jet at
the selected object to be washed.
5. Hold the lance the appropriate distance
away from the surface being cleaned
to avoid damaging it. If working on a
delicate surface a further away distance is
advised (see below for suggested cleaning
methods)
6. Release the trigger to stop the water jet
Note:
Many cleaning tasks may be
completed through the use of water only, but
the removal of dirt is more efficient when a
suitable detergent is used.
In situations where detergent is needed
1. Unscrew the regulator cap of the detergent
tank, pour liquid detergent into the tank,
then screw the cap back in.
2. The machine will suck detergent
