13
Note: If you are using the 2D 520-RF then refer to the 2D setup chart starting on page 24.
Code 3 of 9 (Code 39)
Enable Code 39
0
Disable Code 39
1
Enable Full ASCII Code 39
2
Disable Full ASCII Code 39
3
Enable Code 39 Accumulate Mode
4
Disable Code 39 Accumulate Mode
5
Enable Start/stop character transmission
6
Disable Start/Stop character transmission
7
Enable Mod 43 Check Digit
8
Disable Mod 43 Check Digit
9
Enable Check Digit Transmission
A
Disable Check Digit Transmission
B
Caps Lock ON
C
Caps Lock OFF
D
See
page 20
for information about
Accumulate Mode (
this setting also controls Code 93 and Code 128
)
.
Enabling Start/Stop character
transmission means that the RF Laser Reader will transmit the
*
Start/Stop
characters to your computer along with the data. For example, data of 1234 would be transmitted as
*1234*
.
Enabling the Mod 43 Check Digit
requires the units position of your data to match the calculation for the
check digit explained in
Appendix C
.
If you've enabled the check digit
, enabling Check Digit transmission causes the reader to transmit it to your
computer along with the bar code data.
"Caps Lock ON"
means that for all codes lower case letters read as data will be transmitted as upper case,
and upper case as lower. Numbers, punctuation & control characters are not affected. This applies to Code
128 and Code 93 also.
"Caps Lock OFF"
means that letters will be transmitted exactly as read.
Summary of Contents for 520-RF
Page 1: ......
